Choose a wick trial from the supplier’s guidance for your exact wax and container’s inside diameter, then burn-test the complete formula. Wick numbers are not interchangeable between series. Jar diameter alone does not establish a safe candle.

Starting examples by wax and diameter

These selected examples come from CandleScience’s current wick guide. They are starting candidates for testing, not verified recipes for your fragrance, dye or container.

Inside diameter SimplySoy Artisan Golden Brands 464 Coconut Apricot
2 inches CD 4 CD 4 AL100
2.5 inches CD 8 CD 8 AL140
3 inches CD 20 CD 18 LX 18
3.5 inches Two LX 12 CD 22 Two AL110

The supplier guide states a 7.5% fragrance load and no dye. Changes to the formula can change the result. Consult the full supplier chart for another diameter or wax, including pillar formulations; do not interpolate wick numbers between these examples. A wider or irregular container needs its own assessment.

Before buying, check the wick series, size, length, tab and quantity. These are clearly labeled Amazon searches: CD wicks , LX wicks and Aroma-Lite wicks . Search results may include other series or sellers; a matching number alone is insufficient.

Wax and fragrance batch calculator

Candle wax and fragrance batch calculator

Split a finished batch into wax and fragrance. Enter a permitted load checked against both your exact wax and fragrance documentation, on the same percentage basis.

Example values are loaded. Replace them with your measurements. Your entries stay in this page.

Use the calculator to see your result.

Enter the finished mass of wax plus fragrance, excluding the container and wick. Choose whether the percentage is based on wax mass or finished-mixture mass, and enter the permitted limit on that same basis. Check both the exact wax instructions and the fragrance’s applicable use documentation; use the lower applicable limit after conversion. The calculator cannot verify your entered limit.

For a hypothetical 100 g finished batch at 10% of wax mass, wax is 100 ÷ 1.1 = 90.9091 g and fragrance is 9.0909 g. At 10% of finished-mixture mass, the split is 90 g wax and 10 g fragrance. These examples explain arithmetic; 10% is not a recommended load.

For a wax-basis percentage p, the finished-mixture percentage is 100 × p / (100 + p). In the other direction, a mixture-basis percentage q becomes 100 × q / (100 − q) percent of wax mass. Neither calculation selects a wick or validates combustion safety.

Test the whole candle, with stop conditions

Follow the wax, wick and container suppliers’ instructions, including curing, trimming and test duration. Record the exact materials, quantities, container dimensions and observations for each candidate. Change one variable at a time. An acceptable first burn does not establish behavior later in the candle’s life.

CandleScience describes attended burn cycles, hourly observations and extinguishing after four hours. Stop sooner if the candle behaves unsafely; do not wait for a fourth cycle to act on persistent soot, an unstable flame, damaged glass or other concerning behavior. A full melt pool alone is not a safety certificate.

For normal candle use, the National Candle Association advises a stable heat-resistant surface, supervision, separation from combustibles and stopping with 1/2 inch of wax remaining. A supplier’s controlled test protocol is not permission to burn a household candle down to the bottom. Do not move a candle with liquid wax or use water to extinguish it.

This is desk research and mass arithmetic. No candle recipe or wick was physically tested for this site.

Sources