Start with a dowel and drill bit of the same nominal size, then verify the actual hole and dowel fit on scrap. Metric and inch labels are not interchangeable. A converter can compare measurements; it cannot certify the strength or suitability of a wood joint.

Convert and compare measured diameters

Dowel and hole size converter

Compare two measured diameters. Inch fractions are converted exactly; close metric sizes are not treated as identical.

Example values are loaded. Replace them with your measurements. Your entries stay in this page.

Use the calculator to see your result.

NIST defines one inch as exactly 25.4 mm. Therefore 3/8 inch is 9.525 mm, not 9.5 mm. A measured 9.525 mm hole and 9.5 mm dowel give +0.025 mm of diametral clearance. This is arithmetic on the entered values, not a recommended glue gap.

Inch size Exact millimeters
1/4 6.35
5/16 7.9375
3/8 9.525
1/2 12.7

diametral clearance = hole diameter − dowel diameter

A positive result means the hole is larger; a negative result means the dowel is larger. Zero means only that the entered numbers match. Measurement accuracy, out-of-round holes and wood movement still matter. The clearance is across the diameter, not the radial gap on one side.

Make a joint sample before buying in quantity

  1. Choose the nominal dowel size appropriate to the joint, stock thickness and jig instructions.
  2. Use the matching guide and bit. Clamp the work securely and follow the drilling equipment’s instructions.
  3. Set depth for the actual dowel insertion and required glue allowance without breaking through the far face. Milescraft’s cited jig instructions specify 1/8 inch beyond insertion depth; that is guidance for that setup, not permission to ignore stock thickness.
  4. Drill and try a sample in comparable wood. Do not force a dowel that splits or crushes the surrounding material.
  5. Check alignment and assembly before committing to the final pieces.

Fluted or grooved dowels can provide paths for glue and air, but their nominal diameter still needs to match the intended setup. Neither hardwood nor a particular drill-bit style guarantees the final bore size. A damaged existing hole needs a repair plan rather than an automatically larger dowel.

What to buy

These Amazon searches are shopping routes, not calculated fit recommendations:

The tool shows neighboring 1/64-inch reference fractions up to one inch. These are numerical reference points, not an inventory of sold drill sizes. It applies no assumed wood, moisture or adhesive tolerance, and no joint was load-tested.

Sources